Kahntrol PODMOD Compatible with: Blackhawk Harris - Leg notch and Tension screw style legs Caldwell NcStar PODMOD Details

These adapters allow you to upgrade your typical Harris, Blackhawk, Caldwell, etc bipod and use the quick change Atlas Bipod feet and leg extensions as well as the Hawk Hill Talons for maximum versatility and stability. The PodMod system takes about 10 minutes to install and gives you much more flexibility in your choice of firing positions and ability. They add 1" of height to you bipod, so a 9-13 becomes 10-14. Note on installation: If the podmods do not slip over the leg easily, DO NOT attempt to HAMMER them on. A small percentage of Harris legs are slightly deformed from their cutting process, which makes the tip slightly egged or mushroomed. To address this, take a small file and put a slight chamfer on the end of the leg. This is normally enough to remove the deformity, and allow the podmods to slip on with little effort. If the are still too snug to slip on, you can heat the podmod and/or cool the leg, much like installing bearings. PodMod adapters are currently known to fit the following bipods: Blackhawk Harris - Leg notch and Tension screw style legs Caldwell NcStar Includes one pair of PodMod adapters, you will need one set of compatible feet. Please note, this is a semi-permanent modification to the bipod and the original bipod feet that you remove will not work with the adapters, therefore if you do not already own any Atlas feet you will need them.