EGW Deltapoint Pro Colt Gold Cup Sight Mount

Hot Deals Advertise

Home /
Optics /
EGW Deltapoint Pro Colt Gold Cup Sight Mount - No...

EGW Deltapoint Pro Colt Gold Cup Sight Mount - No Elevation Screw

Best

CAD $79.99

09.11.2022

CAD $79.99

08.11.2022

CAD $79.99

07.11.2022

CAD $79.99

06.11.2022

Go to Shop

EGW Deltapoint Pro Colt Gold Cup Sight Mount - No Elevation Screw Details

7075 Aluminum Matte Black Hardcoat 1.604" .99" (2) 6-32 Button Head Screws, (1) 6-32 Set Screw, (1) 6-32 Torx Head Screw Leupold DeltaPoint Pro, JPoint, Shield RMS/RMSc/SMS, Redfield Accelerator, Optima, Holosun 407K/507K Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. The elevation screw from the original rear sight is re-used in the center hole on this mount. An extra screw is available for purchase below as well. Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included. - Remove the rear sight* - Install the EGW Sight Mount in the dovetail - Tighten set screw (if applicable) - Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) - Apply blue Loctite to the provided mounting screws - Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.